API Guide

show mac-address-table
Display the MAC address table.
C9000 Series
Syntax
show mac-address-table [address mac-address | interface interface | vlan vlan-
id] [aging-time] [dynamic | static] [count [vlan vlan-id] [interface interface-
type [slot [/port]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the nn:nn:nn:nn:nn:nn
format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses the
switch dynamically learns. Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specifically configured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan vlan-
id.
aging-time Enter the keyword aging-time to display only aging-time information.
interface interface (OPTIONAL) Enter the keyword interface then the interface type, slot and port
information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface then the interface type, slot
and port information, as above, you can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC address
assigned to the VLAN. The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an interface or VLAN ID, to
display total or interface-specific static addresses, dynamic addresses, and MAC
addresses in use.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
Layer 2 979