CLI Guide

Version Description
9.10(0.0)
Added the optional dell-diag and onie parameters.
Introduced the no-confirm option.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If you use only the reload command, the system boots into the Dell EMC Networking OS.
If there is a change in the running configuration, the system prompts you to save the new configuration
when you reload the system using the reload command. You can also save your running configuration
manually using the copy running-config command.
You can use the conditional parameter if any configuration changes made to the NVRAM, such as,
stack-group and fanout configurations, must be saved.
When you use the reload command after making configuration changes, the system prompts you to
update the hash for the startup configuration using the verified boot hash command.
Example
DellEMC# reload
Verified startup-configuration is enabled, Hash for startup-
configuration is invalid.
Please update Hash for the startup-configuration before reload.
Example
The following example shows how to reload the system:
DellEMC# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
DellEMC#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
DellEMC#reload onie
Proceed with reload [confirm yes/no]: yes
114 Control and Monitoring