Setup Guide

EXEC mode or EXEC Privilege mode
show cam-acl
• Provides information on FP groups allocated for the egress acl.
CONFIGURATION mode
show cam-acl-egress
Allocate at least one group for L2ACL and IPv4 ACL.
The total number of groups is 4.
Assigning an IPv6 Address to an Interface
Essentially, IPv6 is enabled in Dell EMC Networking OS simply by assigning IPv6 addresses to individual router interfaces. You can use IPv6
and IPv4 together on a system, but be sure to differentiate that usage carefully. To assign an IPv6 address to an interface, use the ipv6
address command.
NOTE: If you assign an IPv6 address to an interface enabled with DAD, Dell EMC Networking OS consider the assigned
IPv6 address as tentative and will not use the address until the DAD verification is done. The time for an IPv6 address to
become active increases as the number of DAD attempts increase.
You can configure up to two IPv6 addresses on management interfaces, allowing required default router support on the management port
that is acting as host, per RFC 4861. Data ports support more than two IPv6 addresses.
When you configure IPv6 addresses on multiple interfaces (the ipv6 address command) and verify the configuration (the show
ipv6 interfaces command), the same link local (fe80) address is displayed for each IPv6 interface.
• Enter the IPv6 Address for the device.
CONFIG-INTERFACE mode
ipv6 address ipv6 address/mask
• ipv6 address: x:x:x:x::x
• mask: The prefix length is from 0 to 128
NOTE:
IPv6 addresses are normally written as eight groups of four hexadecimal digits. Separate each group by a
colon (:). Omitting zeros is accepted as described in Addressing.
Assigning a Static IPv6 Route
To configure IPv6 static routes, use the ipv6 route command.
NOTE:
After you configure a static IPv6 route (the ipv6 route command) and configure the forwarding router’s
address (specified in the ipv6 route command) on a neighbor’s interface, the IPv6 neighbor does not display in the
show ipv6 route command output.
• Set up IPv6 static routes.
CONFIGURATION mode
ipv6 route [vrf vrf-name] prefix interface-type slot/port [/subport] forwarding router tag
• vrf vrf-name:(OPTIONAL) name of the VRF.
• prefix: IPv6 route prefix
• slot/port [/subport]: interface type and slot/port[/subport]
• forwarding router: forwarding router’s address
• tag: route tag
Enter the keyword interface then the type of interface and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
414
IPv6 Routing