Setup Guide

Removing a Command from EXEC Mode
To remove a command from the list of available commands in EXEC mode for a specific privilege level, use the privilege exec
command from CONFIGURATION mode.
In the command, specify a level greater than the level given to a user or terminal line, then the first keyword of each command you wish to
restrict.
Moving a Command from EXEC Privilege Mode to EXEC
Mode
To move a command from EXEC Privilege to EXEC mode for a privilege level, use the privilege exec command from
CONFIGURATION mode.
In the command, specify the privilege level of the user or terminal line and specify all keywords in the command to which you want to allow
access.
Allowing Access to CONFIGURATION Mode Commands
To allow access to CONFIGURATION mode, use the privilege exec level level configure command from
CONFIGURATION mode.
A user that enters CONFIGURATION mode remains at his privilege level and has access to only two commands, end and exit. You must
individually specify each CONFIGURATION mode command you want to allow access to using the privilege configure level
level command. In the command, specify the privilege level of the user or terminal line and specify all the keywords in the command to
which you want to allow access.
Allowing Access to Different Modes
This section describes how to allow access to the INTERFACE, LINE, ROUTE-MAP, and ROUTER modes.
Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-MAP, and ROUTER modes, you
must first allow access to the command that enters you into the mode. For example, to allow a user to enter INTERFACE mode, use the
privilege configure level level interface tengigabitethernet command.
Next, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which you want to allow access using the
privilege {interface | line | route-map | router} level level command. In the command, specify the privilege
level of the user or terminal line and specify all the keywords in the command to which you want to allow access.
To remove, move or allow access, use the following commands.
The configuration in the following example creates privilege level 3. This level:
• removes the resequence command from EXEC mode by requiring a minimum of privilege level 4
• allows access to CONFIGURATION mode with the banner command
• allows access to INTERFACE tengigabitethernet and LINE modes are allowed with no commands
• Remove a command from the list of available commands in EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Move a command from EXEC Privilege to EXEC mode.
CONFIGURATION mode
privilege exec level level {command ||...|| command}
• Allow access to CONFIGURATION mode.
CONFIGURATION mode
privilege exec level level configure
• Allow access to INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode. Specify all the keywords in the command.
CONFIGURATION mode
privilege configure level level {interface | line | route-map | router} {command-keyword
||...|| command-keyword}
• Allow access to a CONFIGURATION, INTERFACE, LINE, ROUTE-MAP, and/or ROUTER mode command.
Management
55