Users Guide

Version Description
7.7.1.0 Introduced on the E-Series.
Related
Commands
● ip redirect-list – enable an IP Redirect List.
ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this
command multiple times.
Syntax
ip redirect-group redirect-list-name test [l2–switch]
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
redirect-list-
name
Enter the name of a configured redirect list.
l2–switch Enter the keyword l2–switch to enable PBR on Layer2 (switched) traffic.
Defaults None
Command Modes INTERFACE (conf-if-vl-)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced the l2–switch attribute.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Usage
Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of
configured rules. These rules includes the next-hop IP address where the incoming traffic is to be
redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise, the normal
routing table is used to forward traffic. When a redirect-group is applied to an interface and the next-hop
is reachable, the rules are added into the PBR CAM region. When incoming traffic hits an entry in the
CAM, the traffic is redirected to the corresponding next-hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
1224 Policy-based Routing (PBR)