Users Guide
Example
Dell(conf)#udf-tcam ipnip seq 1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
deny (for Standard IP ACLs)
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}}[count [byte]] [dscp value] [order]
[fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {source [mask] | any | host ip-address} command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding which
the generation of ACL logs is terminated. with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval
minutes
(OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The time interval range is from 1 to 10
minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring
is not enabled.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.3(0.0) Added support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.
282 Access Control Lists (ACL)