Users Guide

If you disable the enforce-first-as command, it can be viewed using the show ip protocols
command.
In the event of an enfore-first-as check failure, the existing BGP session is flapped.
Related
Commands
● show ip bgp neighbors — view the information the BGP neighbors exchange.
● show ip protocols — view information on routing protocols.
bgp fast-external-fallover
Enable the fast external fallover feature, which immediately resets the BGP session if a link to a directly connected external peer
fails.
Syntax
bgp fast-external-fallover
To disable fast external fallover, use the no bgp fast-external-fallover command.
Defaults Enabled
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
The bgp fast-external-fallover command appears in the show config command output.
The fast external fallover configuration is applied only after you manually reset all the existing BGP
sessions. As a result, after you execute this command, you must also manually execute the clear ip
bgp command in order for the configuration to take effect.
bgp four-octet-as-support
Enable 4-byte support for the BGP process.
Syntax
bgp four-octet-as-support
368 Border Gateway Protocol