Users Guide

Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
● For DNS, enter the keyword dns.
● For FTP, enter the keyword ftp.
● For NTP, enter the keyword ntp.
● For Radius, enter the keyword radius.
● For sFlow collectors, enter the keyword sflow-collector.
● For SNMP (traps and MIB responses), enter the keywords snmp .
● For SSH, enter the keyword ssh .
● For Syslog, enter the keyword syslog.
● For TACACS, enter the keyword tacacs.
● For Telnet, enter the keyword telnet.
● For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
application (for HTTP and ICMP)
Configure the management egress interface selection for HTTP and ICMP.
NOTE:
Only the options that have been newly introduced are described here. For a complete description on all of the
keywords and variables that are available with this command, refer the respective Command Reference Guide of the
applicable platform of the Release 9.2(0.0) documentation set.
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all |
application-type} command.
750 Interfaces