Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
clear ip fib stack-unit
Clear all FIB entries in the specified stack unit (use this command with caution, refer to Usage Information.)
Syntax
clear ip fib stack-unit unit-number vrf vrf-name
Parameters
unit-number Enter the number of the stack unit.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to clear all FIB entries
corresponding to that VRF.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.19.0 Introduced on the S4820T.
Usage
Information
To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
● show ip fib stack-unit — show FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
Syntax
clear ip route [vrf vrf-name] {* | ip-address mask}
IPv4 Routing 785