White Papers

Version Description
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Dell EMC Networking OS supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and SNMP traps when the
L3 host table or route table utilization goes above the threshold.
If you do not configure this command, traps that controlled by this command are not sent. If you do not
specify a notification-type and notification-option, all traps are enabled.
Related
Commands
● snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address vrf vrf-name udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote
ip-address vrf vrf-name udp-port port-number engineID] command.
Parameters
local engineID
Enter the keyword local followed by the engine ID number that identifies the
copy of the SNMP on the local device.
Format (as specified in RFC 3411): 12 octets.
● The first four octets are set to the private enterprise number.
● The remaining eight octets are the MAC address of the chassis.
remote ip-
address
Enter the keyword remote followed by the IP address that identifies the copy of
the SNMP on the remote device.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF that is used to reach the
device.
NOTE: Use this attribute to specify the VRF that is used by the SNMP engine
to reach the device. If no VRF is specified, then the default VRF is used.
udp-port port-
number engineID
Enter the keywords udp-port followed by the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
1504 Simple Network Management Protocol (SNMP) and Syslog