White Papers

Version 8.3.7.0 Introduced on the S4810.
Usage
Information
Save your changes before resetting the system or all your changes will be lost.
setenv
Configure system settings.
Syntax
setenv [gatewayip address | primary_image f10boot location |
secondary_image f10boot location | default_image f10boot location | ipaddre
address | ethaddr address | enablepwdignore | stconfigignore]
Parameters
gatewayip
address
Enter the IP address for the default gateway.
primary_image Enter the keywords primary_image to configure the boot parameters used in
the first attempt to boot Dell Networking OS.
secondary_image Enter the keywords secondary_image to configure boot parameters used if the
primary operating system boot selection is not available.
default_image Enter the keywords default_image to configure boot parameters used if the
secondary operating system boot parameter selection is not available.
NOTE: The default location should always be the internal flash device
(flash:), and a verified image should be stored there.
location Enter the location of the image file to be loaded. When using this command,
the keyword f10boot must precede the location. For example, primary_image
f10boot tftp://10.10.10.10/server.
ipaddr Enter the keyword ippaddr to configure the system management IP address.
ethaddr Enter the keyword ethaddr to configure system management MAC address.
address Enter the IP address in standard IPv4 format and the MAC address in standard
MAC format.
enablepwdignore Enter the keywords enableprdignore true to reload the system software
without the enable password configured.
stconfigignore Enter the keywords stconfigignore true to ignore the startup configuration
file when reloading the system.
Command Modes uBoot
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
1630 u-Boot