White Papers

network backdoor
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Although Dell EMC Networking OS does not generate a route due to the backdoor config, there is an
option for injecting/sourcing a local route in the presence of network backdoor config on a learned route.
permit bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to permit incoming or outgoing
traffic.
Syntax
permit bandwidth
To disable this setting, enter the no permit bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for permitting traffic. The range is from 0 to 102400.
Defaults N/A
Border Gateway Protocol 405