White Papers

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0. Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy
of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”, and “Route-
map” sections in the Dell EMC Networking OS Configuration Guide.
cam-threshold
Configure CAM threshold value for sending the syslog message on CAM usage. Configure silence period for stop receiving
syslog message on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period
{default | silence-period-value}
Defaults
Enabled
Parameters
threshold default
Enter the keyword default for CAM usage threshold for notification of the CAM
usage through syslog message. The default threshold value is 90 percent.
threshold
threshold-
percent
Enter the threshold percent for notification of the CAM usage through syslog
message. The range is from 1 to 100 percent.
silence-period
default
Enter the keyword default to set the silence period for receiving syslog message
regarding CAM usage for CAM region, slot/portpipe. The default silence period is 0
seconds.
silence-period
silence-period-
value
Enter the silence period for stop receiving syslog message for the respective CAM
region, slot/portpipe. The range is from 0 to 65535 seconds.
Command Modes CONFIGURATION
Supported Modes
Command
History
Version Description
9.14.1.0 Introduced on the S4810 and S4820T.
9.13.0.0 Introduced on the MXL, FN IOM, S5000, S4048-ON, S6000, S6000-ON, S3048-
ON, S3100 Series, C9010, S4048T-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON.
Usage
Information
The no cam-threshold command will set the CAM threshold to 90 percent and silence period to 0.
Content Addressable Memory (CAM) 461