White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

561

562

563

564

565

566

567

568

569

570

Table Of Contents

Introduced in Dell EMC Networking OS version 7.8.1.0, DHCP snooping was available for Layer 3 only and

dependent on DHCP Relay Agent (ip helper-address). Dell EMC Networking OS version 8.2.1.0

extends DHCP Snooping to Layer 2. You do not have to enable relay agent to snoop on Layer 2

interfaces.

ipv6 dhcp snooping

Enable DHCPv6 snooping globally for ipv6.

Syntax

[no] ipv6 dhcp snooping

To disable the snooping globally, use the no ipv6 dhcp snooping command.

Defaults Disabled

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000-ON, and Z-Series.

ipv6 dhcp snooping vlan

Enable ipv6 DHCP Snooping on VLAN or range of VLANs.

Syntax

[no] ip dhcp snooping vlan vlan-id

To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no ipv6 dhcp snooping

vlan <vlan-id> command.

Parameters

vlan-id

Enter the name of a VLAN id or list of the VLANs to enable DHCP Snooping.