Administrator Guide

Enter the keyword interface then the type of interface and slot/port information:
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information.
DellEMC#show run int Te 2/2
!
interface TenGigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
DellEMC#
Clearing IPv6 Routes
To clear routes from the IPv6 routing table, use the following command.
● Clear (refresh) all or a specific route from the IPv6 routing table.
EXEC mode
clear ipv6 route [vrf vrf-name] {* | ipv6 address prefix-length}
○
vrf vrf-name:(OPTIONAL) name of the VRF.
○ *: all routes.
○ ipv6 address: the format is x:x:x:x::x.
○ mask: the prefix length is from 0 to 128.
NOTE:
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated
by a colon (:). Omitting zeros is accepted as described in Addressing.
Disabling ND Entry Timeout
When a peer system warmboots or performs an ISSU, the ND entries in the local system may time out resulting in traffic loss.
You can configure the system to keep the learnt neighbor discovery entries stateless so that the ND entries do not time out. To
configure the system to keep the learnt neighbor discovery entries stateless, follow these steps:
● Disable the ND timer:
INTERFACE
ipv6 nd disable-reachable-timer
● To reenable the ND timer, use the no form of the command:
INTERFACE
no ipv6 nd disable-reachable-timer
The following example shows how to disable the ND timer.
DellEMC(conf-if-fo-1/1/1)#ipv6 nd disable-reachable-timer
Configuring IPv6 RA Guard
The IPv6 Router Advertisement (RA) guard allows you to block or reject the unwanted router advertisement guard messages
that arrive at the network device platform.
To configure the IPv6 RA guard, perform the following steps:
1. Configure the terminal to enter the Global Configuration mode.
EXEC Privilege mode
446
IPv6 Routing