CLI Guide

Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the Z9500.
Usage
Information
By default, iSCSI flows are assigned to dot1p priority 4.
iscsi enable
Globally enable iSCSI optimization.
C9000 Series
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization feature.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the Z9500.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
C9000 Series
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults 4 (0x10 in the bitmap)
Command Modes PROTOCOL LLDP (only on the global, not on the interface)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
1000 iSCSI Optimization