CLI Guide

PE Console Commands
To configure a C1048P port extender from an attached PE console, you can use the following commands. Use these commands
when the port extender cannot connect to a C9010.
You can also enter the PE console commands to debug an error condition in a PE stack.
● cd
● clear logging
● copy
● delete
● diag
● dir
● disable
● enable
● exit
● format
● hostname
● offline
● online
● power-cycle
● pwd
● reload
● rename
● reset
● show boot system
● show clock
● show control-bridge status
● show diag
● show diag information
● show diag testcase
● show environment
● show file
● show file-systems
● show interfaces
● show inventory
● show lldp neighbors
●
show logging
● show logging driverlog
● show logging kernellog
● show os-version
● show privilege
● show redundancy
● show revision
● show system
● show tech-support
● show version
● telnet-peer-stack-unit
For information about the commands you can enter from a C9010 console to configure a port extender, see Port Extenders (PE)
chapter.
Topics:
40
1250 PE Console Commands