CLI Guide

N2024-PE 28-port GE/TE
N2024P-PE 28-port GE/TE
N2048-PE 52-port GE/TE
N2048P-PE 52-port GE/TE
N3024-PE 28-port GE/TE
N3024F-PE 28-port GE/TE
N3024P-PE 28-port GE/TE
N3048-PE 52-port GE/TE
N3048P-PE 52-port GE/TE
Dell(conf-pe-201)#
Example (stack
unit type)
Dell(conf-pe-5)#stack-unit 4 type C1048P
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Related
Commands
● redundancy force-failover — Force the standby unit to become the primary or master unit
● reset — Reset or reboot the linecard, RPM, PE and PE stack-unit.
stack-unit
Extend the unused uplink ports as access ports.
Syntax
stack-unit unit-id access—ports port-range
To convert the port back to uplink, use the no stack-unit unit-id access—ports port-
range command.
Parameters
stack-unit unit-id Enter the keyword stack-unit and the stack unit-id number. The stack-unit
range is from 0 to 7.
access-ports
port-range
Enter the keyword access-ports and the port-range, separated by comma.
There are maximum of 4 uplink ports in a PE, and the range is from 1 to 4.
NOTE: Enter the port-range as 1 to 2 for front–end uplink ports and 3 to 4
for uplink ports in back panel (available in N30xx).
Default None
Command Modes PE CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command-Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced support for extending unused uplink port as access-port.
Usage
Information
You can configure the unused uplink port as access-port even on a provisioned PE.
Example
DellEMC(conf)# pe provision 2
DellEMC(conf-pe-2)# stack-unit 1 access-ports 1
DellEMC(conf-pe-2)#
Example (stack
unit type)
Dell(conf-pe-2)# show config
!
pe provision 2
stack-unit 1 type C1048P
PE Stacking 1271