CLI Guide

show config
Display the current monitor session configuration.
C9000 Series
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell(conf-mon-sess-2)#show config
!
monitor session 2 type rpm
source fortyGigE 0/60 destination remote-vlan 300 direction rx
source Port-channel 10 destination remote-vlan 300 direction rx
no disable
Dell#
show monitor session
Display port extender (PE) Gigabit Ethernet interface monitoring information.
C9000 Series
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
To display monitoring information for port extender interface, when added as a source port, use the do
show monitor session command in CONFIGURATION mode.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range is from 0 to 65535.
Defaults none
1386 Port Monitoring