CLI Guide

Version Description
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no
disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related
Commands
disable — disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
C9000 Series
Syntax
show config
Command Modes CONFIGURATION RSTP (conf-rstp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384
1454 Rapid Spanning Tree Protocol (RSTP)