CLI Guide

logging on
Specify that debug or error messages are asynchronously logged to multiple destinations, such as the logging buffer, Syslog
server, or terminal lines.
C9000 Series
Syntax
logging on
To disable logging to logging buffer, Syslog server and terminal lines, use the no logging on
command.
Defaults Enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
When you use the no logging on command, messages are logged only to the console.
Related
Commands
logging — enables logging to the Syslog server.
logging buffered — sets the logging buffered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
C9000 Series
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16383.
● For the management interface on the RPM, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
0 to 1 and the port range is 0.
Simple Network Management Protocol (SNMP) and Syslog 1635