CLI Guide

events (OPTIONAL) Enter the keyword events to debug STP events.
general (OPTIONAL) Enter the keyword general to debug general STP operations.
root (OPTIONAL) Enter the keyword root to debug STP root transactions.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the software only sends
information on BPDUs for the last interface specified.
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
C9000 Series
Syntax
description {description}
To remove the description from the spanning tree, use the no description {description}
command.
Parameters
description Enter a description to identify the spanning tree (80 characters maximum).
Defaults none
Command Modes SPANNING TREE (The prompt is “config-stp”.)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
1658 Spanning Tree Protocol (STP)