CLI Guide

Related
Commands
bgp client-to-client reflection — enables route reflection between the route reflector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that
attribute belong to the same community grouping.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address | peer-group-
name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to all routers
within the peer group.
extended Optional. Enter the keyword extended to send extended community attribute.
standard Optional. Enter the keyword standard to send standard community attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.
Before using this command, you must execute the clear ip bgp command.
neighbor shutdown
Disable a BGP neighbor or peer group.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-
name} no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
378 Border Gateway Protocol