CLI Guide

net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not configure a
NET, the IS-IS process does not start.
C9000 Series
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-
title
Specify the area address and system ID for an IS-IS routing process. The first 1 to
13 bytes identify the area address. The next 6 bytes identify the system ID. The last
1 byte is the selector byte, always identified as zero zero (00). This argument can
be applied to an address or a name.
Defaults Not configured.
Command Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
C9000 Series
Syntax
passive-interface interface
To delete a passive interface configuration, use the no passive-interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For Loopback interface, enter the keyword loopback then a number from 0 to
16383.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
844 Intermediate System to Intermediate System (IS-IS)