CLI Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
C9000 Series
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ipv4 unicast-host-route
Enable the storage of IPv4 route prefixes in the L3 host table.
C9000 Series
Syntax
[no] ipv4 unicast-host-route
Defaults Disabled; by default, all IPv4 route prefixes are stored installed only in the Longest Prefix Match (LPM)
table.
IPv4 Routing 923