CLI Guide

Field Description
Address Displays the IP addresses assigned to the host.
Example
Dell#show hosts
Default domain is not set
Name/address lookup uses static mappings
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
Dell#
Related
Commands
traceroute — views the DNS resolution.
ip host — configures a host.
show ip cam linecard
View CAM entries for a port pipe on a line card..
C9000 Series
Syntax
show ip cam linecard number port-set pipe-number [ip-address mask [longer-
prefixes] | index index-number | summary | vrf vrf instance]
Parameters
number Enter the number of the line card.
pipe-number Enter the number of the line card’s port-pipe. The range is from 0 to 1.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. Enter the keyword longer-prefixes to view routes with a common
prefix.
index index-
number
(OPTIONAL) Enter the keyword index then the CAM index number. The range
depends on CAM size.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number of routes that can be entered into the CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF instance name to
show CAM information as it applies to that VRF instance.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
IPv4 Routing 931