Setup Guide

Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>] {ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}
[track <obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask
| any | host ip-address} {destination mask | any | host ip-address}
[operator] command.
Parameters
redirect Enter the keyword redirect to assign the sequence to the redirect list.
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword slot / port followed by the slot/port information.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
● icmp for internet control message protocol
● ip for any internet protocol
● tcp for transmission control protocol
● udp for user datagram protocol
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP flags:
● ack = acknowledgement
● fin = finish (no more data from the user)
● psh = push function
1212 Policy-based Routing (PBR)