Setup Guide

Example
DellEMC(conf)#logging version ?
<0-1> Select syslog version (default = 0)
DellEMC(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse [number] |
summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the output. The range is
from 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only information in the Syslog
history table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog messages in FIFO
(first in, first out) order.
summary (OPTIONAL) Enter the keyword summary to view a table showing the number of
messages per type and per slot. Slots *7* and *8* represent RPMs.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Example (Partial)
DellEMC#show logging
Syslog logging: enabled
1562 Simple Network Management Protocol (SNMP) and Syslog