Setup Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
● set automatic-tag — compute the tag value of the route.
● set level — specify the OSPF area for route redistribution.
● set metric-type — specify the route type assigned to redistributed routes.
● set tag — specify the tag assigned to redistributed routes.
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Syntax
set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the no set metric-type command.
Parameters
internal Enter the keyword internal to assign the Interior Gateway Protocol metric of
the next hop as the route’s BGP MULTI_EXIT_DES (MED) value.
external Enter the keyword external to assign the IS-IS external metric.
type-1 Enter the keyword type-1 to assign the OSPF Type 1 metric.
type-2 Enter the keyword type-2 to assign the OSPF Type 2 metric.
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
Access Control Lists (ACL) 261