Setup Guide

Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON,
S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage
Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer
expires. Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related
Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
flowcontrol
Control how the system responds to and generates 802.3x pause flow control frames.
Syntax
flowcontrol {rx {off | on} tx {off | on} [negotiate | pause-threshold value
| resume-offset value] | [monitor session-ID]}
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received flow control frames on this
port.
NOTE: Flow-control packets are mirrored only when flow-control rx is
enabled on an interface.
rx off Enter the keywords rx off to ignore the received flow control frames on this
port.
tx on Enter the keywords tx on to send control frames from this port to the connected
device when a higher rate of traffic is received.
tx off Enter the keywords tx off so that flow control frames are not sent from this
port to the connected device when a higher rate of traffic is received.
pause-threshold Enter the buffer threshold limit for generating PAUSE frames.
resume-offset Enter the offset value for generating PAUSE frames to resume traffic.
negotiate (Optional) Enter the keyword negotiate to enable the pause-negotiation with
the egress port of the peer device. If the negotiate command is not used,
pause-negotiation is disabled. 40-gigabit Ethernet interfaces do not support pause-
negotiation
monitor Enter the keyword monitor then the session-ID to enable mirror flow control
frames on the interface. The range is from 0 to 65535.
Defaults rx on tx off
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Added support for monitor session.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
Interfaces 685