Setup Guide

Version Description
9.11(0.0)
Included the FEC BER details in the output for 100G interfaces of S6100–ON and
Z9100–ON.
Added support to display 10GBASE-T information on the S4048, S4048T, S6000,
S6000-ON, S6100, Z9500, S6010, and Z9100.
Included display information about EEE on the S3048–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON. Included display information about
EEE on the S3100 series, S4820T, and S5000.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
9.1(0.0) Updated Management Ethernet output to include two global IPv6 addresses on
S4810 and Z9000 and added output example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6 addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series and C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
6.3.1.0 Added the Pluggable Media Type field in the E-Series output.
Usage
Information
Use the show interfaces command for details on a specific interface.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For receive/transmit power
that is less than 0.000, an snmp query returns the corresponding dbm value even though the CLI
displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it reaches the
maximum line rate. When the maximum line rate is reached, there is no change in the line-rate.
User Information
The following table describes the show interfaces command shown in the 10G example.
712 Interfaces