Setup Guide

Layer 2
This section describes commands to configure Layer 2 features.
Topics:
• MAC Addressing Commands
• Virtual LAN (VLAN) Commands
• Far-End Failure Detection (FEFD)
MAC Addressing Commands
The following commands are related to configuring, managing, and viewing MAC addresses.
clear mac-address-table
Clear the MAC address table of all MAC address learned dynamically.
Syntax
clear mac-address-table {dynamic | sticky }{address mac-address | all |
interface interface | vlan vlan-id}
Parameters
dynamic Enter the keyword dynamic to specify dynamically-learned MAC addresses.
sticky Enter the keyword sticky to specify sticky MAC addresses.
address mac-
address
Enter the keyword address then a MAC address in nn:nn:nn:nn:nn:nn format.
all Enter the keyword all to delete all MAC address entries in the MAC address table.
interface
interface
Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added support for sticky MAC addresses.
31
Layer 2 941