Users Guide

DellEMC(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/1
DellEMC(conf-if-group-vl-1-2,te-1/1)# no shutdown
DellEMC(conf-if-group-vl-1-2,te-1/1)# end
Applying a Privilege Level to a Username
To set the user privilege level, use the following command.
● Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
● Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt is
hostname#, rather than hostname>.
Configuring Logging
The Dell EMC Networking OS tracks changes in the system using event and error messages.
By default, Dell EMC Networking OS logs these messages on:
● the internal buffer
● console and terminal lines
● any configured syslog servers
To disable logging, use the following commands.
● Disable all logging except on the console.
CONFIGURATION mode
no logging on
● Disable logging to the logging buffer.
CONFIGURATION mode
no logging buffer
● Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
● Disable console logging.
CONFIGURATION mode
no logging console
Audit and Security Logs
This section describes how to configure, display, and clear audit and security logs.
The following is the configuration task list for audit and security logs:
● Enabling Audit and Security Logs
Management
61