Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

741

742

743

744

745

746

747

748

749

750

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-6.1.1.0 Introduced for the E-Series.

Usage

Information

To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.

ip name-server

Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.

Syntax

ip name-server ipv4-address [ipv4-address2...ipv4-address6]

To remove a name server, use the no ip name-server ip-address command.

Parameters

ipv4-address

Enter the IPv4 address, in dotted decimal format, of the name server to be used.

ipv4-address2...

ipv4-address6

(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of name

servers to be used. Separate the addresses with a space.

Defaults No name servers are configured.

Command Modes CONFIGURATION