CLI Guide

Version Description
9.11(0.0) Introduced GRE protocol support.
ip access-group
Assign an IP access list (IP ACL) in the monitor session mode.
Syntax
ip access-group access-list-name
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
Defaults Not enabled.
Command Modes
MONITOR SESSION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the command under the MONITOR SESSION mode on the S6000,
S6100–ON, and Z9100–ON.
ipv6 access-group
Assign an IPv6 access list (IPv6 ACL) in the monitor session mode.
Syntax
ipv6 access-group access-list-name
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
Defaults Not enabled.
Command Modes
MONITOR SESSION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced the command under the MONITOR SESSION mode on the S6100–ON,
Z9100–ON, S6000, S6000–ON, and S5048F-ON.
monitor multicast-queue
Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command Modes CONFIGURATION
1202 Port Monitoring