CLI Guide

Examples
DellEMC(conf-router_bgp)# no bgp regex-eval-optz-disable
DellEMC(conf-router_bgp)# do show ip protocols
Routing Protocol is "ospf 22222"
Router ID is 2.2.2.2
Area Routing for Networks
51 10.10.10.0/00
Routing Protocol is "bgp 1"
Cluster Id is set to 10.10.10.0
Router Id is set to 10.10.10.0
Fast-external-fallover enabled
Regular expression evaluation optimization enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
DellEMC(conf-router_bgp)#
Related
Commands
● show ip protocols — view information on all routing protocols enabled and active on the E-Series.
bgp router-id
Assign a user-given ID to a BGP router.
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only that BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces are
configured, the highest IP address of a physical interface on the router.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol 361