CLI Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

401

402

403

404

405

406

407

408

409

410

Table Of Contents

This command is global for all VRFs.

set extcommunity bandwidth

Enables you to set extended community bandwidth.

Syntax

set extcommunity bandwidth

To disable extended community bandwidth, enter the no set extcommunity bandwidth command.

Parameters

bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The

range is from 0 to 102400.

Defaults N/A

Command Modes ROUTER MAP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S-Series.

Usage

Information

A new policy command is introduced in order to attach the Link Bandwidth extended community only

to the prefixes that are received from a neighbor that satisfy the desired conditions. This command is

relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no

change to the set of supported conditions or filters.

During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual

LB extended community, the system will attach the AS number and encode the bandwidth in floating

point format.

show capture bgp-pdu neighbor

Display BGP packet capture information for an IPv4 address on the system.

Syntax

show capture bgp-pdu neighbor ipv4-address

Parameters

ipv4-address

Enter the IPv4 address (in dotted decimal format) of the BGP address to display

packet information for that address.

Command Modes EXEC Privilege