Deployment Guide

You can configure an IP subnet or address on a physical or VLAN interface that overlaps the same IP
subnet or address configured on another interface only if the interfaces are assigned to different VRFs. If
you assign two interfaces to the same VRF, you cannot configure overlapping IP subnets or the same IP
address to them.
Example
DellEMC# configure terminal
DellEMC(conf)# ip vrf red
DellEMC(conf-vrf)# description "Red Network"
DellEMC(conf-vrf)# show config
!
ip vrf red 4
description "Red Network"
DellEMC(conf-vrf)#
DellEMC(conf-if-te-1/1/4/1)# int tengigabitethernet 1/1/4/2
DellEMC(conf-if-te-1/1/4/2)# no shut
DellEMC(conf-if-te-1/1/4/2)# ip vrf forwarding red
DellEMC(conf-if-te-1/1/4/2)# ip add 100.1.1.1/24
DellEMC(conf-if-te-1/1/4/2)#
DellEMC(conf-if-te-1/1/4/2)#
DellEMC(conf-if-te-1/1/4/2)#
DellEMC(conf-if-te-1/1/4/2)# show config
!
interface TenGigabitEthernet 1/1/4/2
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
DellEMC(conf-if-te-1/1/4/2)#
ip http vrf
Configure an HTTP client with a VRF used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Parameters
management Enter the keyword management for configuring the management VRF that uses
an HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not specify a VRF name, the
HTTP client uses the default VRF.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Virtual Routing and Forwarding (VRF) 1625