Deployment Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage
Information
Applies to EBGP neighbors only.
Configure your system to accept 4-byte formats before entering a 4 byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP
neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS
numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ip-address | peer-group-name} route-
map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
NOTE: This command sends routes to peers only if an outbound policy is
configured and if there is a change in the existing outbound policy.
Defaults Not configured.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
Border Gateway Protocol 393