Setup Guide

● Duplicate Address Detection (DAD) — Before configuring its IPv6 address, an IPv6 host node device checks whether
that address is used anywhere on the network using this mechanism.
● Prefix Renumbering — Useful in transparent renumbering of hosts in the network when an organization changes its
service provider.
NOTE: As an alternative to stateless autoconfiguration, network hosts can obtain their IPv6 addresses using the dynamic
host control protocol (DHCP) servers via stateful auto-configuration.
NOTE: Dell EMC Networking OS provides the flexibility to add prefixes on Router Advertisements (RA) to advertise
responses to Router Solicitations (RS). By default, RA response messages are sent when an RS message is received.
Dell EMC Networking OS manipulation of IPv6 stateless autoconfiguration supports the router side only. Neighbor discovery
(ND) messages are advertised so the neighbor can use this information to auto-configure its address. However, received ND
messages are not used to create an IPv6 address.
NOTE: Inconsistencies in router advertisement values between routers are logged per RFC 4861. The values checked for
consistency include:
● Cur Hop limit
● M and O flags
● Reachable time
● Retrans timer
● MTU options
● Preferred and valid lifetime values for the same prefix
Only management ports support stateless auto-configuration as a host.
The router redirect functionality in the neighbor discovery protocol (NDP) is similar to IPv4 router redirect messages. NDP uses
ICMPv6 redirect messages (Type 137) to inform nodes that a better router exists on the link.
IPv6 Headers
The IPv6 header has a fixed length of 40 bytes. This fixed length provides 16 bytes each for source and destination information
and 8 bytes for general header information.
The IPv6 header includes the following fields:
● Version (4 bits)
● Traffic Class (8 bits)
● Flow Label (20 bits)
● Payload Length (16 bits)
● Next Header (8 bits)
● Hop Limit (8 bits)
● Source Address (128 bits)
● Destination Address (128 bits)
IPv6 provides for extension headers. Extension headers are used only if necessary. There can be no extension headers, one
extension header or more than one extension header in an IPv6 packet. Extension headers are defined in the Next Header field
of the preceding IPv6 header.
IPv6 Header Fields
The 40 bytes of the IPv6 header are ordered, as shown in the following illustration.
Figure 49. IPv6 Header Fields
368
IPv6 Routing