Users Guide

line Line Configuration mode
route-map Route map configuration mode
router Router configuration mode
Examples: Deny Network Administrator from Using the show users Command.
The following example denies the netadmin role from using the show users command and then verifies that netadmin
cannot access the show users command in exec mode. Note that the netadmin role is not listed in the Role access:
secadmin,sysadmin, which means the netadmin cannot access the show users command.
DellEMC(conf)#role exec deleterole netadmin show users
DellEMC#show role mode exec show users
Role access: secadmin,sysadmin
Example: Allow Security Administrator to Configure Spanning Tree
The following example allows the security administrator (secadmin) to configure the spanning tree protocol. Note command is
protocol spanning-tree.
DellEMC(conf)#role configure addrole secadmin protocol spanning-tree
Example: Allow Security Administrator to Access Interface Mode
The following example allows the security administrator (secadmin) to access Interface mode.
DellEMC(conf)#role configure addrole secadmin ?
LINE Initial keywords of the command to modify
DellEMC(conf)#role configure addrole secadmin interface
Example: Allow Security Administrator to Access Only 10-Gigabit Ethernet Interfaces
The following example allows the security administrator (secadmin) to only access 10-Gigabit Ethernett interfaces and then
shows that the secadmin, highlighted in bold, can now access Interface mode. However, the secadmin can only access
10-Gigabit Ethernet interfaces.
DellEMC(conf)#role configure addrole secadmin ?
LINE Initial keywords of the command to modify
DellEMC(conf)#role configure addrole secadmin interface tengigabitethernet
DellEMC(conf)#show role mode configure interface
Role access: netadmin, secadmin, sysadmin
Example: Verify that the Security Administrator Can Access Interface Mode
The following example shows that the secadmin role can now access Interface mode (highlighted in bold).
Role Inheritance Modes
netoperator
netadmin Exec Config Interface Router IP RouteMap Protocol MAC
secadmin Exec Config Interface Line
sysadmin Exec Config Interface Line Router IP RouteMap Protocol MAC
Example: Remove Security Administrator Access to Line Mode.
The following example removes the secadmin access to LINE mode and then verifies that the security administrator can no
longer access LINE mode, using the show role mode configure line command in EXEC Privilege mode.
DellEMC(conf)#role configure deleterole secadmin ?
LINE Initial keywords of the command to modify
DellEMC(conf)#role configure deleterole secadmin line
DellEMC(conf)#do show role mode ?
configure Global configuration mode
exec Exec Mode
interface Interface configuration mode
line Line Configuration mode
route-map Route map configuration mode
router Router configuration mode
770
Security