White Papers

Version Description
9.11.0.0 Introduced on all Dell EMC Networking OS platforms.
Usage
Information
The output of the show interfaces command displays the configured rate interval, along with the
collected traffic data.
When rate-interval is not configured in the global configuration mode or interface mode, the default value
of 299 seconds is applied.
When rate-interval is configured only in the global configuration mode and not in the interface mode, the
global rate-interval value is applied at the interface level also.
When rate-interval is configured at the interface level and not in the global configuration mode, the
interface level rate-interval value is applied for an interface.
When rate interval is configured in both global configuration mode as well as interface mode, then the
rate-interval value configured at interface level is applied as it takes precedence over the global value.
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
DellEMC(conf-if-fo-1/4)# show config
!
interface fortyGigE 1/4
no ip address
mtu 9216
switchport
710 Interfaces