Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
show lldp neighbors — displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
C9000 Series
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the interface
dead. The range is from 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
pe-lldp-multiplier
Configure the port extender (PE) LLDP multiplier value.
Syntax
pe-lldp-multiplier number
Link Layer Discovery Protocol (LLDP) 1059