Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1061

Parameters

interface

(OPTIONAL) Enter the following keywords and the interface information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then

the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;

the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1

to 48.

● For a port extender 10-Gigabit Ethernet interface, enter the keyword

peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range

is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-

id range is 25 to 28 or 49 to 52 depending on the PE.

detail (OPTIONAL) Enter the keyword detail to display all the TLV information, remote

management IP addresses, timers, and LLDP tx and rx counters.

Defaults None

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.13.0.1P1 Introduced peTenGigE interface support on the C9010.

9.13.0.0 Enhanced to display organizational specific unrecognized LLDP TLVs.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.1.(0.0) Modified output of detail parameter to display remote management IP addresses.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series.

Usage

Information

Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.

Example

DellEMC(conf-if-te-1/31)# do show lldp neighbors

Loc PortID Rem Host Name Rem Port Id Rem Chassis Id

1062 Link Layer Discovery Protocol (LLDP)