Administrator Guide

Interface: TenGigabitEthernet 0/1
Link Local address: fe80::201:e8ff:fe40:4d11
IPSecv6 policy name: OSPFv3-1-600
inbound ah sas
outbound ah sas
inbound esp sas
spi : 600 (0x258)
transform : esp-des esp-sha1-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
outbound esp sas
spi : 600 (0x258)
transform : esp-des esp-sha1-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
show ipv6 ospf interface
View OSPFv3 interface information.
C9000 Series
Syntax
show ipv6 ospf [process-number] [vrf vrf-name][interface]
Parameters
process-number Enter the OSPF process number.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and the name of the VRF to display neighbors
corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are displayed.
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a Null interface, enter the keywords null 0.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes
EXEC
Open Shortest Path First (OSPFv2 and OSPFv3) 1251