Administrator Guide

show running-config local
Use show running-config local to view the local configurations.
C9000 Series
Syntax
show running-config local
Default None
Command Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage
Information
Use show running-config local to view only the configurations corresponding to the local
chassis.
Example
Dell#show running-config local
Current Configuration ...
! Version 1-0(0-4370)
! Last configuration change at Tue Nov 3 09:56:27 2015 by default
!
boot system rpm0 primary tftp://10.16.127.35/sys-vg-2
boot system rpm0 secondary tftp://10.16.127.36/sys-vg-2
boot system rpm0 default system: A:
boot system rpm1 primary tftp://10.16.127.35/sys-vg-2
boot system rpm1 secondary tftp://10.16.127.36/sys-vg-2
boot system rpm1 default tftp://10.16.127.35/sys-vg-2
boot system gateway 10.16.130.254
!
no logging console
!
hostname Dell
!
redundancy auto-failover-limit count 3 period 60
redundancy auto-synchronize full
!
enable password 7 b125455cf679b208fcf9eeeed0cd6d84
!
username admin password 7 1d28e9f33f99cf5c
!
linecard 0 provision C9000LC2410G
!
interface TenGigabitEthernet 0/0
no ip address
no shutdown
!
interface TenGigabitEthernet 0/1
no ip address
no shutdown
!
interface TenGigabitEthernet 0/2
no shutdown
!
interface TenGigabitEthernet 0/3
no ip address
no shutdown
!
interface TenGigabitEthernet 0/4
no ip address
no shutdown
Port Extenders (PE)
1365