Administrator Guide

44507301 packets input, 3563070343 bytes
Input 44506754 IP Packets, 0 Vlans 0 MPLS
41 64-byte pkts, 44502871 over 64-byte pkts, 249 over 127-byte pkts
407 over 255-byte pkts, 3127 over 511-byte pkts, 606 over 1023-byte
pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
1218120 packets output, 100745130 bytes, 0 underruns
Output 5428 Multicasts, 4 Broadcasts, 1212688 Unicasts
1216142 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 299 sec):
Input 01.50Mbits/sec, 2433 packets/sec
Output 00.02Mbits/sec,4 packets/sec
Time since last interface status change: 00:22:34
Dell#
Usage
Information
The following describes the show interfaces port-channel brief command shown in the
following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
● L3 — for Layer 3
● L2 — for Layer 2
Status Displays the status of the port channel.
● down — if the port channel is disabled (shutdown)
● up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
● In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
● In Layer 3 port channels, the primary port is not indicated.
Example
Dell# sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Te 2/0 (Up) *
Te 2/1 (Down)
Te 2/2 (Up)
Dell#
Example (port-
range)
Dell#show interfaces port-channel 1-2 brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status Uptime Ports
1 L3 down 00:00:00 Te 11/1 (Down)
Related
Commands
show lacp — displays the LACP matrix.
796 Interfaces