Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

851

852

853

854

855

856

857

858

859

860

Version Description

9.9(0.0) Introduced on the C9010.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Usage

Information

Configure a network entity title (the net command) to specify the area address and the router system

ID.

Enable routing on one or more interfaces to establish adjacencies and establish dynamic routing.

You can configure only one IS-IS routing process to perform Level 2 routing. A level-1-2 designation

performs Level 1 and Level 2 routing at the same time.

Commands

● ip router isis — configures IS-IS routing processes for IP on interfaces and attaches an area

designator to the routing process.

● net — configures an IS-IS network entity title (NET) for a routing process.

● is-type — assigns a type for a given area.

set-overload-bit

Set the overload bit in zeroth fragment of non-pseudonode LSPs on the router.. This setting prevents other routers from using

it as an intermediate hop in their shortest path first (SPF) calculations.

C9000 Series

Syntax

set-overload-bit

To return to the default values, use the no set-overload-bit command.

Defaults Not set.

Command Modes

● ROUTER ISIS (for IPv4)

● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.