Administrator Guide

ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
C9000 Series
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface
interface
Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number. For the C-Series and S-Series, the range is from 1 to 128.
Defaults Not configured.
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
Dell Networking OS provides the capability of statically configuring the interface to which a multicast
router is attached. To configure a static connection to the multicast router, enter the ip igmp
snooping mrouter interface command in the VLAN context. The interface to the router must be
a part of the VLAN where you are entering the command.
Internet Group Management Protocol (IGMP) 887