API Guide

To ensure that the permit statement or PBR exception is effective, use a lower sequence number, as shown below:
ip redirect-list rcl0
seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Apply a Redirect-list to an Interface using a Redirect-group
IP redirect lists are supported on physical interfaces as well as VLAN and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination
port-channel is shut down, the traffic is dropped.
Use the following command inINTERFACE mode to apply a redirect list to an interface. Multiple redirect-lists can be applied to a redirect-
group. It is also possible to create two or more redirect-groups on one interface for backup purposes.
Table 70. Applying a Redirect-list to an Interface
Command Syntax Command Mode Purpose
ip redirect-group redirect-list-name INTERFACE Apply a redirect list (policy-based routing) to
an interface.
redirect-list-name is the name of a redirect
list to apply to this interface.
FORMAT: up to 16 characters
Delete the redirect list from this interface with the [no] ip redirect-group command.
In this example, the list “xyz” is applied to the tenGigabitEthernet 2/1 interface.
Applying a Redirect-list to an Interface Example:
Dell(conf-if-te-1/1/1)#ip redirect-group test
Dell(conf-if-te-1/1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/1/1)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface. Dell
Networking OS has the capability to support multiple groups on an interface for backup purposes.
Show Redirect List Configuration
To view the redirect list configuration, use the following command in EXEC mode:
Table 71. Viewing the Redirect-list Configuration
Command Syntax Command Mode Purpose
show ip redirect-list redirect-list-name EXEC View the redirect list configuration and the
associated interfaces.
show cam pbr
show cam-usage
EXEC View the redirect list entries programmed in
the CAM.
List the redirect list configuration using the show ip redirect-list redirect-list-name command. The non-contiguous mask is displayed
in dotted format (x.x.x.x). The contiguous mask is displayed in /x format. Some sample outputs are shown below:
Dell#show ip redirect-list explicit_tunnel
IP redirect-list explicit_tunnel:
Defined as:
660
Policy-based Routing (PBR)